Pipe Cutting & Beveling Equipment

Operating Instructions

To adjust for Band radius -

Loosen cap screws "A" one or two turns.
Swing front and rear pairs of legs inward or outward to match band radius.
Snug up cap screws "A". These should not be tightened down hard enough to interfere with the ball leg hinging action.

To adjust Torch Holder –

Loosen set screw "B".
Rotate eccentric torchholder to desired clearance.
Tighten set screw "B" –hand tight.

Maintenance – Occasionally use ice pick or pocketknife to scrape out accumulation in wheel grooves, to assure good crawler wheel/ band contact.

Model 206

One Bevel Transmission
Operates On All Size Bands

For pipe 6" (152.4mm) and larger
Bands are made from durable stainless steel for long life
Adaptable to any beveling requirement
Smoothly, accurately cuts and bevels
Flexible 9' (2.7m) drive shaft, standard; 14' (4.3m) optional
Motorized drive optional
Minimum clearance needed in bell holes
Fully adjustable cutting head angle
Out-round pipe attachments unnecessary
Precision cast for more rugged strength
Mounts easily anywhere on the pipe
Above 60" (1524mm) - special order

Standard Drive Shaft

Model 206-9 and Model 206-14. Standard Band-Type Beveling Machine with 9' or 14' (2.7m - 4.3m) transmission drive shaft.

Double Cut Torch Holder

Model 283D. Double Cut Torch Holder fits any Sawyer Band-Type Beveling Machine. Allows machine to bevel on both sides of a cut.

Motorized Transmission

Model 206F-110, Model 206F-220 and Model 206F-90DC. Motorized Band-Type Beveling Machine with A.C. or D.C. motorized transmission.

Adjustable Torch Holder

Model 284D. Adjustable Torch Holder fits any Sawyer Band-Type Beveling Machine. Torch sold separately.

Right Angle Drive

Model 206A-RA. Standard Band-Type Beveling Machine with Right Angle Drive and 9 ft. (2.7m) drive shaft. Special swivel feature on drive shaft facilitates work in tight areas, enabling machine to be operated from the left or right side or from above or below.